Rotary Push-control Wall Dimmer RPC
Rotary Push-control Wall Dimmer RPC
0-10V dimming and switching rotary module to fit into plates and grid systems
2-wire 0-10V control of Multiload’s dimming and switching products and other drives. DALI rotary control using Multiload’s DALI Converter
Rotary Push-control Wall Dimmers RPC fit into wall plates and grid systems from UK manufacturers, including MK GridPlus, Wandsworth, Hamilton, Forbes and Lomax, Focus SB, Scolmore and others
All modules available to match any style or finish
TECHPACK CONTAINS:
Technical specification and installation
Related product options
Wiring diagrams
Download pdf here
PRODUCT ORDER CODES:
RPC1
2-wire control of a single drive unit or a Multiload dimming and switching product
RPC2
2-wire control of between 2-20 drives or Multiload dimming and switching products
0-10V dimming and switching rotary module to fit into plates and grid systems
- Dimming control (1-10V) and switching to 0V using only 2-core cable
- Desired dimming range achieved by using minimum and maximum brightness pre-sets
- Brightness varies over full rotation of control knob
- To be used with RPC Related Products, including Lighting Contactors (LC series), Trailing-edge Dimmer (ADT400), Leading-edge Dimmer (AD2500) and third party drives
- Allowing use for most retrofit situations
- Enables DALI rotary dimming when used with Multiload DALI Converter (see Related Products)
Available in two standard modules
- RPC1 – for a single Multiload unit or a third-party drive
- RPC2 – for 2-25 Multiload units or third-party drives, maintaining the full signal range up to 10V maximum brightness
Available in a full range of plate finishes
- RPC fits into wall plates and grid systems from UK manufacturers, including MK GridPlus, Wandsworth, Hamilton, Forbes and Lomax, Focus SB and others
- A wide range of options is available. To ensure correct product finish is ordered, please call Multiload on 020 7794 9152
- Specials for UK or international plate systems are possible – please call us for advice
- Retrofit installation of RPC, dimming and mains switching can be achieved by using the existing 2-core cable to the plate in combination with Related Products
Output
- 0 -10V signal terminals: C1 (0V) and C2 (+ve 0 -10V). 1-10V is achieved by rotating the knob. When the switch is activated, it outputs 0V
- Manually adjustable pre-sets. These allow adjustment of minimum and maximum brightness range, to suit individual signal characteristics of drives from different manufacturers. Adjustable pre-sets also enable control over the full rotation of the control knob, eliminating ‘dead spots’
- Further adjustments can be made to trim in desired lighting levels. This means that, if lighting levels are too bright, they can be reduced and, if too low, they can be increased
- It’s important to set the minimum pre-set first. Setting the maximum will not affect the minimum setting